Carrera Decoder Speedflow Mini Frankenslot Set with LED cable / interference filter
Frankenslot Speedflow Digital Decoder V2.1 compatible with the Carrera ® Digital System D132 / D124
Attention: solder sensitive components at max. 275 degrees for 1 - 2 seconds, first tin the soldering pads and cables, then solder them on! If you ignore this, you may destroy the Schottky diode at the plus input!
Separate brake / tail light , Ghostcar ™ function, refueling
Size approx. 27.0 x 15.0 mm
Operating voltage 12 - 18.0 volts DC
(* Release only for 18D Carrera motor, BISON I, Slotdevil 5020 without magnetic operation)
Weight 1, 8 grams - one-sided assembly / underside free, but with additional soldering pads
PLEASE note picture 2 - the connection sketch
Attention - a Vishay diode is included, the long leg is the anode and therefore plus!
Please pay attention to
the scope of delivery:
Digital decoder Speedflow
silicone wire 0.25 m² for motor / guide keel and soft PVC wire 0.14 m² for LED
2 LED white clear, 2 LED red clear, 1 IR diode
and a set of ceramic capacitors which must be soldered in must be used with BRM, NSR and RevoSlot engines.
We recommend always soldering in the interference suppression capacitors to avoid interference in the digital protocol - see Figure 4!
For installation in third-party models, a 3 mm hole must be drilled 12.5 mm off-center on the left in the direction of travel.
If a separate brake/tail light is not desired, a bridge must be soldered between the BL - RL soldering pads.
The decoder is set up as normal via CU using the code button or by double-clicking / lifting / putting on / pressing the switch button again (the respective ID). . Also suitable for external race software such as Cockpit-XP.
The LEDs are connected via Plus + and switched via ground.
Connections V2.1:
Track RL / Rail
M + - / Motor
FL / Front light
BL / Brake light
RL / Rear light
+ LED / common plus for LED
A K / IR diode
